Architectural Salvage

Set of 2 Antique Door Hinges with Japanned Copper Flash Finish and Cannonball Pin Top.

These are the Stanley Sweetheart hinges with the "SW" in a heart stamped into the back of each hinge piece.

Hinges measure 3 1/2 inches wide x 3 1/2 inches tall when flat.

Pin pulls out, making for two separate hinge sections.

Comes with 12 original screws.  6 for each hinge.

Condition is very good with some small pits, scratches and small spots of finish loss.

It also looks like some have a layer of clear varnish from when the door frame would have originally been finished, including some small drips.

5 sets of 2 hinges, with screws, available at time of listing.

If you would like more than one set please select a higher quantity from the drop down.

Thank you!

This fantastic antique architectural salvage piece is made of metal.  It was used as a wall heat register cover and was made by Jones.  Dates to circa 1900.  Ornate Victorian design in brown.

Measures 12 1/8 inches wide x 12 5/8 inches tall and about 1 1/4 inches deep.

Very good used condition with some small scratches, paint chipping, and some wear near the bottom.

Holes at each side near the center.  Could by hung on the wall and used for flower arrangement or magazine rack.

Would look amazing in a farmhouse or cottage chic setting!

This fantastic antique architectural salvage piece is made of metal.  It was used as a wall heat register cover and was made by Jones.  Dates to circa 1900.  Ornate Victorian design in black.

Measures 12.25 inches wide x 12.5 inches tall and about 1 1/4 inches deep.

Very good used condition with some small scratches, paint chipping, and some wear near the bottom.  Also is slightly bent along one side of the back near the bottom.

Holes at each side near the center.  Could by hung on the wall and used for flower arrangement or magazine rack.

Super cute in a farmhouse or cottage decor!

Vintage circa 1940s trunk handles, lifting handles, or chest handles.  Set of 2 primitive rusty cast iron handles.

Pair comes with 8 original bolts, 4 per handle and 8 original nuts, 4 per handle.

Each measure just over 3 1/2 inches wide on the plate and the handle measures almost 4 1/2 inches at the widest point.  Screw holes at the bottom are on 2 5/8 inches on center.  Top holes are 2 inches on center.

Handle only lifts half way, so it can be used to lift a heavy object.

Bolts measure 2 1/8 inches long.

Very good condition with a rusty patina and white paint remnants around the edges.  Both handles move freely.

You will receive 2 handles, 8 bolts, and 8 nuts with this purchase.

Great for your next restoration project or craft project.

Vintage circa 1970s Early American style drawer pull with faux keyhole and polished brass finish.  These are made of some kind of metal.

Stamped on the back KBC.

Measure 4 1/2 inches wide and just over 2 1/4 inches tall.  Screw holes are on 3 inch center.

Comes with 2 original screws for installation.  Screws measure 3/4 of an inch long.

Good condition with normal wear to the finish.  With some of the finish totally rubbed off in spots.

10 pulls available at time of listing.  If you need more than one, please select a quantity from the drop down menu.

Thank you!